49” x 49” X/Y Travels with Mitsubishi M700 CNC Controller, 60HP Intensifier Pump with 60K PSI, WaterCAD/CAM Programming System, Touch Probe Sensor Positioning Cutting Head, Water Level Control for Submerged Machining, Ebbco Filtration and Closed Loop System, Ebbco In-Line Chiller, Solids Separation System and under 50 Hours Operation/Use

GENERAL SPECIFICATIONS

• Table Size: 66" X 60" (grate-top)
• X-axis Travel: 49"
• Y-axis Travel: 49"
• Z-axis Travel: 7"
• Cutting Speed Max: 500 IPM
• Width Distance Between Columns: 65"
• Height Under Traveling Bridge: 11.5"
• Intensifier Pump Pressure: 60,000 PSI
• Intensifier Pump Model: XP-60
• Intensifier Pump Motor: 60 Hp
• High-pressure Flow Rate : 1.2 Gpm
• Intensifier Ratio (oil/water): 20
• Controller: Mitsubishi M700 3-axis CNC Controller
• Drive System: Mitsubishi AC Servo System (3-axis)
• Programming/Operating System: Watercad CAD/CAM Programming
• Height Control: Controlled Self-positioning Cutting Head Probe
• Water System: 3 Vessel Ebbco 140 Gal. Closed Loop System
• Bacteria Control: Ebbco Ozone Generator Module
• Heat Control: Ebbco In-line Chiller
• Abrasive Hopper: Vespa 670 LB Capacity
• Water Level Control: 200 Gallon Air Pressure Tank/Vessel
• Abrasive Recovery System: Ebbco Solids Separation System

INCLUDES: Mitsubishi M700 CNC Controller, 60HP Intensifier Pump with 60K PSI, WaterCAD/CAM Programming System, Touch Probe Sensor Positioning Cutting Head, Water Level Control for Submerged Machining, Ebbco Filtration and Closed Loop System, Ebbco In-Line Chiller, Solids Separation System and under 50 Hours Operation/Use

 ***We strongly encourage personal inspection of all pieces of used equipment***

***All Price, Location and Specifications Subject to Change without Notice***